PRE-RIDE INSPECTION
WARNING
Perform a pre-ride inspection before each ride to detect potential problems
during operation. The pre-ride inspection can help you monitor wear and
deterioration before they become a problem. Correct any problems that
you discover to reduce the risk of a breakdown or crash. See an authorized
Sea-Doo dealer as necessary.
Before performing the pre-ride inspection, read and understand the
CONTROLS
section.
What to Do Before Launching the Watercraft
WARNING
Engine should be off and the tether cord cap should always be removed
from the engine cut-off switch prior to verifying any of the following points.
Only start watercraft once all items have been checked and operate prop-
erly.
Check the items listed in the following table before launching the watercraft.
ITEM OPERATION
✓
Hull Inspect.
Jet pump water intake Inspect/clean.
Drain plugs Tighten.
Fuel tank Refill.
Engine compartment
Check for any fluid leaks and gasoline vapor
odor.
Engine oil level
Check/refill.
Engine coolant level
Check/refill.
Steering system Check operation.
Throttle lever
Check operation.
iBR lever
Check operation.
Intelligent Suspension (iS) Check operation.
Front storage compartment cover,
boarding platform and seat
Ensure they are closed and latched.
Self-contained removable storage bin
Ensure it is installed on water
craft and
properly closed and latched.
Wakeboard rack (WAKE Pro model)
– Ensure rack is properly
installed and
secured.
– Make sure bungee cords are in good
condition.
– Ensure wakeboard is correctly installed
in rack and secured
.
42
_______
SAFETY I
NFORMATION
________
To Next Page
Loading...
Need help?
General