EasyManuals Logo

Sea-doo 2012 Sea Doo RXT series User Manual

Sea-doo 2012 Sea Doo RXT series
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
PRE-RIDE INSPECTION
NOTE: To allow engine starting, the
tether cord cap must be properly in-
stalled on the engine cut-off switch
within 5 seconds of pressing the
START/STOP button.
Restart the engine, then stop it by re-
moving the tether cord from the engine
cut-off switch.
WARNING
Should the tether cord cap be
looseorfailtoremainontheen-
gine cut-off switch, replace the
tether cord immediately in order
to avoid unsafe use. If remov-
ing the tether cord cap from the
engine cut-off switch or pressing
the START/STOP button does not
stop the engine, do not use the
watercraft. See your authorized
Sea-Doo dealer.
What to Do After
Launching the Watercraft
Check the items listed in the follow-
ing table after launching the watercraft
and before going for a ride.
ITEM OPERATION
Information Center
Check
operation.
Intelligent Brake and
Reverse System
(iBR)
Check
operation.
Variable Trim System
(VTS)
Check
operation.
Information Center (Gauge)
1. Press START/STOP button and
install tether cord on the engine
cut-off switch.
2. As the information center cycles
through its self-test function, en-
sure all indications come on.
WARNING
Always attach the tether c
ord clip
to your PFD.
iBR System
NOTICE
Ensure there is sufficient
space ahead and behind watercraft
to safely carry out the iBR system
test to avoid a collision. Watercraft
will move during test.
1. Remove the moorings securing the
watercraft to the dock.
2. Start the engine and ensure the wa-
tercraft does not move.
3. On the left handlebar, depress the
iBR lever completely in, the wa-
tercraft should move slowly back-
wards.
4. Release the iBR lever, there should
not be any reverse thrust.
WARNING
Always ensure proper iBR system
operation before taking the water-
craft out for a ride.
Variable Trim System (VTS)
Withtheenginerunninginforward
thrust, use the VTS
TM
system to move
the jet pump nozzle up, and then down
alternately to check VTS operation.
Confirm the VTS position indicator
movement in the information center.
Also test the VTS preset trim positions
(if equipped).
46
_______
SAFETY I
NFORMATION
________

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo 2012 Sea Doo RXT series and is the answer not in the manual?

Sea-doo 2012 Sea Doo RXT series Specifications

General IconGeneral
BrandSea-doo
Model2012 Sea Doo RXT series
CategoryBoat
LanguageEnglish

Related product manuals