EasyManuals Logo

Sea-doo 2012 Sea Doo RXT series User Manual

Sea-doo 2012 Sea Doo RXT series
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #115 background imageLoading...
Page #115 background image
OPERATING MODES
When deactivating SLOW SPEED
MODE by pressing the cruise button,
or accelerating using the throttle lever,
the iBR gate stays in the forward posi-
tion.
When using the iBR lever, the iBR gate
will move towards the reverse posi-
tion, then neutral when the lever is
released.
SLOW SPEED MODE deactivation will
be indicated in the following manner:
The CRUISE indicator will go out
The scrolling SLOW SPEED MODE
ACTIVE message will cease.
Ski Mode
Wake Pro Model
Ski mode allows for repeated and pre-
cisely controlled launches, and a set
towing speed, designed specifically
for towing a skier or wake boarder.
Ski mode is only available using a nor-
mal key, it is not available when using a
LEARNING key or a RENTAL key.
RAMP Function
The RAMP function available in ski
mode is a pre-programmed function
used for launching and accelerating
the PWC when towing a skier or wake-
boarder.
RAMP 1 provides for the smoothest
launch and most gradual acceleration.
RAMP1alsoprovidesfortheslowest
TARGET SPEED range.
RAMP 5 provides for the quickest
launch and most rapid acceleration.
RAMP 5 also providesthehighest TAR-
GET SPEED range.
The RAMP setting that is selected by
default when entering ski mode may
be changed to a different setting.
TARGET SPEED Function
The TARGET SPEED functionlimits the
maximum towing speed.
Once the RAMP has been selected,
an average PWC target speed for that
RAMP will be visible in the numerical
display.
The average speed displayed and the
speed range available is dependent on
the RAMP selected. The higher the
RAMP number, the higher the speed
range.
The operator may increase or decrease
the targetspeedto any valuewithin the
selected RAMP speed range.
If the desired target speed cannot be
set in the selected RAMP, you must
exit then reengage SKI MODE, and se-
lect a different RAMP.
Engaging and Using Ski Mode
To engage ski mode, carry out the fol-
lowing steps:
1. Press the MODE button repeatedly
until SKI MODE is visible in the mul-
tifunction display.
sdd2009-001-024_e
1. MODE button
smo2010-002-116
SELECTED FUNCTION - SKI MODE
______________
113

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo 2012 Sea Doo RXT series and is the answer not in the manual?

Sea-doo 2012 Sea Doo RXT series Specifications

General IconGeneral
BrandSea-doo
Model2012 Sea Doo RXT series
CategoryBoat
LanguageEnglish

Related product manuals