MAINTENANCE PROCEDURES
F18J04Y
21
TYPICAL — INSPECT THESE AREAS
1. Water intake
2. Ride plate
Ski/Wakeboard Post
(Wake)
Ski/Wakeboard Post Inspection
Check ski/wakeboard post operation.
Ensure it slides up and down easily.
Check locking mechanism operation.
Check fasteners tightness. If some-
thing is found defective, don't use
ski/wakeboard post and see an autho-
rized Sea-Doo dealer for repair.
Ski/Wakeboard Post Lubrication
Clean ski/wakeboard post and apply
a light coat of SUPER LUBE GREASE
(P/N 293 550 030).
Lubricate post throughout its length.
Wipe off all excess grease and reinstall
post.
Extend and retract several times to dis-
tribute the lubricant.
Fuses
Fuse Removal and Installation
Use the fuse remover/installer in-
cluded in the fuse box to ease fuse
removal.
Fuse Inspection
If an electrical problem occurs, check
the fuses. If a fuse is burnt, replace by
one of the same rating.
A15E0KZ
1
2
3
TYPICAL
1. Fuse
2. Check if melted
3. Ampere rating
WARNING
Do not use a higher rated fuse
as this can cause severe dam-
age. If a fuse has burnt out, the
source of the malfunction should
be determined and corrected be-
fore restarting. See an authorized
Sea-Doo dealer for servicing.
Fuse Location
All fuses are located inside a single
fuse box.
To access the fuse box:
iS Models
Open the boarding platform.
______________
137
To Next Page
Loading...
Need help?
General