MULTIFUNCTION GAUGE
9) Multifunction Display
The multifunction display is used to:
– Display the WELCOME message
on power up.
– Display the KEY recognition mes-
sage.
– Provide various indications as se-
lected by the operator.
– Activating and setting various func-
tions and modes of operation.
– Display scrolling messages of func-
tion activation or system faults.
– Display fault codes.
NOTE: The default indication in the
multifunction display is the compass
direction.
10) Water Depth Display
GTX Limited iS Model
The water depth display provides an in-
dication of the lake water depth.
The system is capable of indicating wa-
ter depth under the hull in single incre-
ments up to 50 m (164 ft).
NOTE: Under certain conditions, the
display may stop indicating. The dis-
play ability to provide an indication of
the water depth depends on the condi-
tions of use.
1
2
smo2009-002-114_r
GTX LIMITED iS
1. Depth finder indicator
2. Water depth indication
NOTE: The water depth indication is
only available when a depth sounder is
installed and detected.
WARNING
Never use the depth sounder as a
warning device to ride in shallow
water.
11) Water Temperature
Display
All Models Except GTX 155
Continuously displays surface water
temperature.
smo2009-002-114_t
WATER TEMPERATURE DISPLAY
The numerical display may also be se-
lected to display water temperature.
See
NUMERICAL DISPLAY
in this sec-
tion.
To change the unit of measurement
(°C or °F), see your authorized Sea-Doo
dealer.
12)HourMeterDisplay(HR)
Continuously displays the accumu-
lated engine hours.
62
______________
To Next Page
Loading...
Need help?
General