PRE-RIDE INSPECTION
WARNING
Check iBR lever operation before
starting the engine. If any friction
is felt in the iBR lever, refer to an
authorized Sea-Doo dealer.
iS Suspension
iS Models
1. Press briefly the START/STOP but-
tontowake-uptheECM.
2. Press on iS UP/DOWN arrow button
to confirm suspension operation.
Storage Compartments, Boarding
Platform and Seat
Ensure all required safety and survival
equipment and any additional cargo is
properly stored in the storage bins pro-
vided.
Ensure the self-contained storage bin
cover, front cover, glove box, boarding
platform, access panels, and seat are
closed and latched.
WARNING
Ensure the seat, boarding plat-
form, access panels, and all stor-
age compartment covers are se-
curely latched.
iS Models
Ensure there are no items of cargo, or
other material, between the moving
deck and fixed deck.
WARNING
Do not store cargo or material of
any type in the space between the
moving and fixed deck, or near
the rear suspension control arm.
These areas must remain free of all
obstructions to permit free move-
ment of the deck and any water
which may accumulate in the foot
wellareas. Useonlyprovidestor-
age compartments.
Wakeboard Rack
WAKE Pro Model
WARNING
Ensure wakeboard rack is properly
secured to watercraft body, and
that the wakeboard is properly po-
sitioned and secured to the rack
prior to using watercraft. Ensure
wakeboard retaining straps are in
good condition.
Ski/Wakeboard Post
WAKE Pro Model
Make sure ski/wakeboard post is fully
extended and locked before use.
Completely retract and lock when not
used.
WARNING
Use caution with skier/wake-
boarder in tow as tow rope may
backlash to watercraft when re-
leased. Never perform a sharp
turn when towing a skier, wake-
boarder or any toy.
NOTICE
The ski/wakeboard post is
designed for towing a skier or wake-
boarder with a maximum gross
weight of 114 kg (250 lb).
Engine Cut-Off Switch and Engine
START/STOP Button
Press the start button once without
installing the tether cordon the engine
cut-off switch.
Install the tether cord cap on the en-
gine cut-off switch.
Press the START/STOP button to start
the engine, then stop it by pressing the
START/STOP button a second time.
________
SAFETY INF
ORMATION
________
45
To Next Page
Loading...
Need help?
General