PRE-RIDE INSPECTION
RXTiS,GTXiSandGTXLimitediS
Models
Also remove the ventilation box by de-
pressing the 3 locking tabs and lifting it
off the deck extension.
smo2009-002-002_b
1. Ventilation box
2. Locking tabs
smo2009-002-003
VENTILATION BOX REMOVED
Engine Oil
Ensure oil level is within specification
as described in
MAINTENANCE PRO-
CEDURES
section.
Engine Coolant
Ensure coolant level is within specifi-
cation as described in
MAINTENANCE
PROCEDURES
section.
All Models Except iS
Check for coolant leaks on engine, in
bilge and from ride plate.
CAUTION When operating the
engine with the watercraft out of
the water, the engine and heat ex-
changer in the ride plate may be-
come very hot. Avoid any contact
with hot engine parts and the ride
plate as burns may occur.
Steering System
Assisted by another person, check
steering operation for free movement.
When the handlebar is horizontal,
the jet pump nozzle should be in the
straight ahead position. Ensure the jet
pump nozzle pivots easily and in the
same direction as the handlebar (e.g.:
when handlebar is turned to the left,
the nozzle opening must point towards
the LH side of watercraft).
WARNING
Check handlebar and correspond-
ing steering nozzle operation be-
fore starting. Never turn handle-
bar while someone is near the rear
of the watercraft. Keep away from
steering moving parts (nozzle, iBR
gate, linkages etc.).
Throttle Lever
Check the Electronic Throttle Control
lever (ETC) for free and smooth opera-
tion. It should return to its initial posi-
tion immediately after it is released.
WARNING
Check throttle lever operation be-
fore starting the engine. If any fric-
tion is felt in the throttle lever, refer
to an authorized Sea-Doo dealer.
iBR Lever
Check the iBR lever for free and
smooth operation. It should return
to its initial position immediately after
it is released.
44
_______
SAFETY I
NFORMATION
________
To Next Page
Loading...
Need help?
General