SeaSTAR OPTIMUM EPS - Using Datalink

C-1
© 2014 SeaStar Solutions Optimus Installation Manual, Rev. E
APPENDIX C USING DATALINK
Datalink is a software tool that can be used for system setup and
configuration. Although most of these functions can be performed
with the color CANtrak display, experienced users may find it quicker
to use Datalink for these tasks.
C.1 Dealer Tools
C.2 Connection
To use Datalink with an Optimus system you will need the following
items, supplied with kit EPSK1206:
•IXXATUSBtoCANconverter,part#214720
•Programmingharness,6-pinFCItoserial,part#CM21010
•Programmingharness,DeviceNettoserial,part#CM21106(used
for Optimus 360 systems only)
You will also need a Windows
®
–compatible notebook computer with
Datalink installed on it. See Appendix E for information on how to
download and install the latest version of the software.
Connect the IXXAT converter to a USB port on your computer, and
connect the sub-D connector on harness CM21010 to the IXXAT.
Plug the other end of harness CM21010 into an available CAN1 port
on the helm or the PCM as shown in figure C-1. If you don’t have any
spare ports an optional wye harness (CM21702) is available that
can convert a single port into two.
ALWAYS REINSTALL THE CAN1 SEALING PLUGS WHEN YOU
DISCONNECT THE PROGRAMMING HARNESS.
WARNING