SeaSTAR OPTIMUM EPS - Installation Overview; Installation Summary

To Next Page

To Previous Page

3-1

3.0 INSTA LLATION OVERVIEW

3.2 Installation Summary

To ensure proper installation and maintenance of this steering

system, please note the following:

• InstallationmustbeperformedbyaSeaStarSolutionsauthorized

installer.

• Readandunderstandallinstallationinstructionsprovidedwith

the system and its components before starting the installation.

• Readandunderstandallthesafetyinformationnotedinthis

manual and all other installation instructions..

If you need technical assistance, or wish to report an error in our

documentation, please contact SeaStar Solutions technical support:

Technical Support

Web: www.seastarsolutions.com

E-mail: seastar@@seastarsolutions.com

Phone: 604.248.3858

Fax: 604.279.2202

There are several stages in the installation of the Optimus EPS

system, listed below. By reviewing this summary you will better

understand each step in the context of the entire installation.

3.1 Important Information/Technical

Support Contact

Planning (Section 4)

• Acquire a general understanding of the system and its various

components.

• Check that the equipment supplied is available and correct.

• Establish suitable locations for each component.

• Plan the cabling and the hose connections.

• Consider the power connections to the battery and the breaker

location. All wiring should be done to ABYC guidelines.

• Considerwheretheignitionandtachsourceswillcomefrom.

• Verifythatyouhaveadealersetupkitforpurge&calibration.

• Make a diagram of the system as it pertains to the particular

boat installation.