© 2014 SeaStar Solutions Optimus Installation Manual, Rev. E
5-24
Each SmartCylinder is supplied with and 18 foot (5.5 m) harness. Route
the harness for each SmartCylinder as shown below. A Starboard exit
harness is preferred, but a Port harness is acceptable if there is a
smooth harness bend which is securely tied back to the fitting. Sensor
harness MUST be secured to the hydraulic hoses every six inches (15 cm).
Harness ends MUST be marked PORT or STARBOARD (on single engine
applications mark the harness PORT, as you will be connecting it to
the port side of the PCM). DO NOT mix up sensor harness
connections at PCM. Identification labels are provided with the kit.
Be sure to mark all hoses using the supplied labels to insure correct
installation. See Section 5.5.1.
Starboard Cable Installation (preferred method)
Figure 5-25.
NOTICE
5.7 Connecting the SmartCylinder
To Next Page
Loading...