SeaSTAR OPTIMUM EPS - Page 22

© 2014 SeaStar Solutions Optimus Installation Manual, Rev. E
3-2
Networks and Wiring (Section 6)
• Review network diagrams
• Install network tees.
• Connect network harnesses.
• Install circuit breakers and run the power wires.
• Connect ignition wires.
• Connect engine RPM source.
• Connect autopilot if required.
Commissioning (Section 8)
• Installation checks
• Sea trial
• Steering adjustments
• Warranty checklist
Component Installation (Section 5)
• Mount the helm.
• Mount the CANtrak.
• Mount the pump control module (PCM) and the power
steering pumps.
• Install the SmartCylinders.
• Install the remote service valves (if necessary).
• Install the hoses.
Purging, Calibration and Setup (Section 7)
• Purge the hydraulic system.
• Calibrate the SmartCylinders
• System setup with CANtrak.