SeaSTAR OPTIMUM EPS - Page 7

© 2014 SeaStar Solutions Optimus Installation Manual, Rev. E
vii
A.3 PCM Mounting Dimensions ..................................... A-11
A.4 Power Steering Pump .............................................. A-12
A.4.1 Power Steering Pump Mounting Dimensions ...... A-12
A.4.2 Floor Mounting the Pumps .............................. A-13
Appendix B – CAN Network .................................................... B-1
B.1 Basic Network ......................................................... B-1
B.1.1 CAN Bus Connectors ....................................... B-2
B.1.2 CAN Bus Connectivity ...................................... B-3
B.1.3 Electrical Harness........................................... B-3
B.1.4 Powering the Bus ............................................ B-4
B.1.5 CAN Bus Power .............................................. B-4
Appendix C – Using Datalink .................................................. C-1
C.1 Dealer Tools ............................................................ C-1
C.2 Connection ............................................................. C-1
C.3 Navigating Datalink .................................................. C-2
C.4 System Setup ......................................................... C-4
C.4.1 System Parameters ........................................ C-4
C.4.2 Settings Menu Access .................................... C-5
C.4.3 Second Station .............................................. C-5
C.4.4 Cycle Power to System .................................... C-5
C.5 Purge with Datalink .................................................. C-6
C.6 Calibrate with Datalink ............................................. C-7
Appendix D – Using the Color CANtrak Display ....................... D-1
D.1 Display Navigation ................................................... D-1
D.2 Documentation Conventions ..................................... D-2
D.3 Initial Startup .......................................................... D-3
D.4 Unlocking the Dealer Menu ...................................... D-3
D.5 Menu Structure ....................................................... D-4
Appendix E – Updating Firmware ............................................ E-1
E.1 Downloading Software Update Files ........................... E-1
E.2 One-Step System Firmware Update ............................ E-2
E.3 Checking Component Firmware Revision Levels ............ E-3
E.3.1 Using the CANtrak ........................................... E-3
E.3.2 Using Datalink ................................................. E-3
E.4 Backing Up Component Configuration Files ................... E-5
E.4.1 Using the CANtrak.............................................E-5
E.4.2 Using Datalink ................................................. E-5
E.5 Updating Individual Components ................................ E-6
E.6 Updating the CANtrak Software .................................. E-6
E.7 Opening a Back-up (ECU) File ...................................... E-7
Appendix F - Bolt Torque Specifications ................................... F-1