STEERING SYSTEM
12 - 5
Steering System Handlebar Disassembly
【A】Lock bolt
【B】Handlebar cover
【C】Steering Handlebar
◆ Loose the handlebar locking bolt 【A】；
◆ Take off the Handlebar cover【B】；
◆ Take off the Handlebar【C】；
C
A
B
D
A
B
C
E
Steering handlebar installation
!
Assure the handlebar matches the angle of the steering
rod, keep in parallel, as shown in the left picture.
【A】Handlebar lower cover
【B】Locking bolt
【C】Locking bolt
【D】Gap
【E】Handlebar upper cover
◆ Place the lower handlebar bracket 【A】on the
steering rod with the holes aligned
◆ Place the handlebar in the center of the handlebar
lower bracket, layer on the handlebar upper cover
【E】, make sure the hole position is aligned with
the lower holes;
◆ Tighten the front locking bolts 【B】, and then
tighten the rear locking bolts 【C】;
Tightening Torque
29N.m
（
2.9kgf·m
，
21.4ft·lb
）
!
Incorrect steps of the locking bolt may make the gap 【D】
between the upper and lower covers uneven.
To Next Page
Loading...
