1 - 7
Operation method
Push
button
Lamp
Effective mode
Auto. Manual
Use
Name
Group
No.
[21]
[22]
[22]
[24]
[25]
[26]
[27]
Feedrate
switches
Optional block
skip
Restart of
block
Power
Standby
Emergency
stop
(Main/Sub-
operation
panel)
Memory
These push button switches select a
manual jog feed rate between 0 mm/
min and 5,000 mm/min.
(In case of the A-axis, it becomes
between 10 deg/min and 1,400 deg/
min.)
This switch makes the block skip
function command by program
effective. During programming, the
slash “/” used.
The RESTART OF BLOCK becomes
effective by pressing this switch and
the indication lamp lights up. This
becomes ineffective by repressing
this switch and the indication lamp
goes out. When the RESET OF
BLOCK is not provided as option,
this switch becomes ineffective and
the indication lamp puts out.
Through designating a sequence No.
that is not restarted by this functions,
the machining can be restarted from
that block.
ON ... turns on the main power to the
NC unit.
OFF ... Turns off the main power.
Drive preparation state as for the NC
unit to make the machine ready for
operation.
Stops the machine completely. All
motors are stopped and the NC unit
is reset.
LOCK... Protects the information
stored in the NC unit. Normally, shift
this switch to “LOCK”.
O
O
O
O
O
O
O
O
O
O
O
_
_
_
O
O
O
_
_
_
O
(Rotary switch)
(Key)
To Next Page