Seiki VS50 - Page 13

1 - 8
Operation method
Push
button
Lamp
Effective mode
Auto. Manual
Use
Name
Group
No.
[28]
[29]
[30]
[31]
[32]
[33]
[34]
[35]
Memory
Speed meter
Load meter
Tool clamp/
unclamp
Optional stop
Single block
Program restart
Manual pulse
generator
(Portable)
WRITE ... Shift this switch to
“WRITE” when writing or correcting
memory information.
Indicates a spindle speed.
Indicates a spindle load to a motor’s
rated power in terms of percentage.
CLAMP ... Clamp a tool to the
spindle.
UNCLAMP ... Unclamp the spindle
tool. When the tool is unclamped, a
yellow lamp lights up and you
cannot run the spindle.
When M01 is commanded in the
tape, tape operation stops after all
the commands in the block are
completed. The indication lamp
lights up. This is released by
repressing the START button and
indication lamp puts out.
Program commands are executed
one block by one block. However,
canned cycles are executed one
cycle by oneb cycle.
The program restarts.
The indication lamp lights up. This
is released by repressing the button
and the indication lamp puts out.
Get the handle mode by the push
button and select the feed axis by
the rotary switch. For a feed rate,
you can select 1 pulse/graduation
(1/1), 10 pulses/graduation (10/1)
and 100 pulses/graduation (100/1).
Since it is portable, you can draw it
out to a convenient position for use.
For inch specifications, you can
select 1/1, 10/1 and 50/1.
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
(Key)
(Meter)
(Meter)
(Toggle
switch)