| 3 - User manual
The LED flashes green to connect to the Base Station.
The LED is green, when the antenna is connected to the Base Station and and
one or both RF channels are active.
Or the LED is yellow, when the antenna is connected to the Base Station and
the radio signal is muted.
Or the LED is flashing green and red, when the firmware is updating
automatically.
If the Base Station is in standby, the DAD is off.
You can connect up to four antennas to one Base Station.
The Base Station has two independend RF channels. Both variants of the antenna
(UHF and 1G4) can be connected to the Base Station at the same time.
To disconnect the antenna from the Base Station:
Hold the push button down.
Unplug the cable from the Base Station.
To disconnect the cable from the antenna:
Hold the snap-in nose down.
Unplug the cable from the antenna.
The antenna has been connected/disconnected.
Related information
Antenna cable extension
104
To Next Page