Sennheiser SPECTERA - Pairing the SEK to the Base Station

| 3 - User manual
Pairing the SEK to the Base Station
Mobile devices can only be paired and operated with one Base Station at a time.
You can pair up to 128 mobile devices to a Base Station within one RF channel.
Please make sure that on the Base Station
• a RF channel is configured and
• this RF channel is activated (RF on).
To pair the SEK to a Base Station:
Put the Base Station into Pairing Mode using LinkDesk or Spectera WebUI.
The LED flashes blue.
Pairing Mode is activated for five minutes. The audio signal is not
interrupted.
While the SEK is off, long-press the ON/OFF button until the Status LED is blue.
The status LED is flashing blue while searching for a new Base Station.
When the SEK found the Base Station, the status LED is flashing blue quickly
and then is blue.
The SEK appears in the software.
Confirm the pairing in the software, see LinkDesk: Adding mobile devices and
Spectera WebUI: Pairing/unpairing mobile devices.
The status LED of the SEK is flashing green quickly while connecting. When
connecting is completed, the status LED is green.
To unpair the SEK from a Base Station:
The SEK can only be unpaired in LinkDesk or Spectera WebUI.
• LinkDesk: Pairing/unpairing mobile devices
• Spectera WebUI: Pairing/unpairing mobile devices
The SEK will automatically switch to pairing mode. The status LED is flashing
blue.
The SEK has been paired to a Base Station.
94