| 3 - User manual
Switching the Base Station on and into standby
The Base Station cannot be switched off. You have to disconnect it from the
power supply, see Connecting/disconnecting the Base Station to/from the
power supply system.
To switch the Base Station on:
Short-press the ON/OFF button.
The Sennheiser Logo appears in the display and the Base Station is booting.
When booting is done, the power button LED lights up white.
To switch the Base Station into standby:
Long-press the ON/OFF button.
The display and the LED go off. The ON/OFF button pulses white.
The DAD goes off.
The Base Station has been switched on/into standby.
50
To Next Page
Loading...
