| 3 - User manual
Updating the Base Station
You can update the firmware of the Base Station via LinkDesk or Spectera WebUI.
All Spectera devices must use the same firmware. The Base Station determines the firmware
version.
Please note that firmware versions are not backward compatible.
NOTICE
Data loss during firmware update
The audio transmission is interrupted during the firmware update of the
Base Station, the antenna or the mobile device.
After the firmware update, the device is restarted automatically.
Do not update the firmware during an active live audio
transmission.
To update the firmware:
If you want to update the Base Station via LinkDesk, follow the steps described here:
Updating firmware (Base Station).
The LED is flashing green and red during the update.
If you want to update the Base Station via Spectera WebUI, follow the steps described
here: Updating firmware (Base Station).
The LED is flashing green and red during the update.
When the update is installed, the Base Station restarts.
The update will be installed on the connected antennas automatically.
The firmware has been updated.
The new firmware is distributed to the other devices via the Base Station.
Updating the SEK
Updating the DAD
68
To Next Page
Loading...
