| 3 - User manual
Charging the rechargeable batteries in the L 6000 charger
To charge the BA 60, BA 61, BA 62 and BA 70 rechargeable batteries with the L 6000
charger, you need the LM 6060, LM 6061, LM 6062 or LM 6070 charging modules.
Before charging, you have to install the charging modules in the L 6000 charger. For
installation information, see Installing a charging module in the L 6000 charger.
Note on the charger firmware
Always use the latest firmware for the L 6000 charger (version 2.0 or later) to
ensure you have access to the full range of functions. You can download the
latest firmware from the following address:
sennheiser.com/l-6000
Note on the BA 62 rechargeable battery for the SK 6212 bodypack transmitter
It is possible that new rechargeable batteries cannot be fully charged to 100 %
in the first few charging cycles.
The remaining operating time may still be unclear after the first few charging
cycles. This will improve over time after more charging cycles because the
rechargeable battery calibrates itself.
NOTICE
Damage to the charging contacts in the charging slot
If you touch the contacts in the charging slot, they may become dirty or
bent.
When replacing and removing the rechargeable batteries, ensure
that you do not touch the charging contacts in the charging slots.
131
To Next Page