Doc# E166703 8-13
8: Using Ethernet Communication
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
wise (unicast) encryption. For example, for CCMP+TKIP, CCMP is the pairwise
encryption and TKIP is the group encryption. CCMP is the default for WPA2.)
TX Data rate: 0=fixed, 1=auto fallback <1>? 1
TX Data rate: 0=1, 1=2, 2=5.5, 3=11, 4=18, 5=24, 6=36, 7=54 Mbps <7>?
Enter data transmission rate, e.g., 7 for 54Mbps.
Minimum Tx Data rate: 0=1, 1=2, 2=5.5, 3=11, 4=18, 5=24, 6=36,
7=54 Mbps <0>? 0
Enable Power management <N>? Y
Enable Soft AP Roaming <N>? N
Max Failed Packets (6-64, 255=disable) <6>? 6
Security Settings (7)
Disable SNMP <N>? N
SNMP Community Name <public>: (You can enter an SNMP community name here.)
Disable Telnet Setup <N>? N (If you change this setting to Y, you will not be able to
use Telnet to re-configure the Network card once you save the settings, without
resetting the Network card, as shown in Section 8.4. However, you may want to dis-
able Telnet setup and Port 77FEh to prevent users from accessing the setup from the
network.)
Disable TFTP Firmware Update <N>? N
Disable Port 77FEh <N>? N (For security purposes, you may want to disable Telnet
setup and Port 77FEh to prevent users from accessing the setup from the network.)
Enable Enhanced Password <N>? N
Exiting the screen
CAUTION! DO NOT PRESS 'D': that will restore the Default Settings.
Press 'S' to Save the settings you've entered.
To Next Page
Loading...
Need help?
General
