Shark MP200 User Manual

Doc# E166703 2-5
2: MP200 Metering System Overview and Specifications
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
• V-Switch
TM
key 3 (V3): Multifunction measurement and 32 MegaBytes* for data
logging
* The table below shows the number of days of logging available with V2 and V3, for
the MP200-Y and MP200-S circuit configurations, based on a 15 minute logging
interval. Note that both MP200-Y and MP200-S units have Historical Log 1; Historical
Log 2 is used for MP200-Y units, only; and Historical Log 3 is used for MP200-S units,
only.
** The number of days shown for Log 1 is based on the default configuration at ship-
ping. Since this log is configurable, the actual number of days depends on the number
of parameters chosen, as well as the logging interval.
Obtaining a V-Switch
TM
Key:
Contact EIG’s inside sales staff at sales@electroind.com or by calling (516) 334-0870
(USA) and provide the following information:
1. Serial number(s) of the MP200 unit(s) you are upgrading. Use the number(s), with
leading zeros, shown in the Communicator EXT
TM
Device Status screen (from the
Communicator EXT
TM
Main screen, click Tools>Device Status).
2. Desired V-Switch
TM
key.
3. Credit card or Purchase Order number. EIG will issue you the V-Switch
TM
key.
Enabling the V-Switch
TM
Key:
1. Open Communicator EXT
TM
software.
2. Power up your MP200 unit.
3. Connect to the MP200 unit through Communicator EXT
TM
software (see Chapter 5).
Model Wiring Log 1 V2** Log 2/3 V2 Log 1 V3** Log 2/3 V3
MP200-Y Three
Phase/ 8
circuits
68 days 105 days 3617 days 2872 days
MP200-S Single
Phase/24
circuits
136 days 47 days 7235 days 1247 days

Shark MP200 Specifications

General

Brand	Shark
Model	MP200
Category	Measuring Instruments
Language	English