Doc# E166703 5-14
5: Communicating with the Meter
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
NOTE: The USB port settings are fixed, i.e., they cannot be changed.
COM 3: RS485/Display Port
Address: 1-247
Protocol: Modbus RTU/ASCII
Baud Rate: 9600, 19200, 38400, 57600
Response Delay: 0-750ms
NOTE: Click the (1)Default to Ethernet or (2)Default to Display button to set either
the (1)Ethernet settings for COM1 or (2)Display settings for COM3, to their default
values.
See Chapter 10 in the Communicator EXT 4.0 and MeterManager 4.0 Software
User Manual. You can download this manual at:
https://electroind.com/downloads/software-downloads/
8. When changes are complete, click the Update Device button to send a new profile
to the meter.
9. Click Exit to leave the Device Profile or click other menu items to change other
aspects of the Device Profile (see the following section for instructions).
To Next Page
Loading...
Need help?
General
