Sharp MX-M266N - Page 107

MX-M316N SIMULATION 6 – 28
26-18
Purpose
Setting
Function (Purpose)
Used to set Disable/Enable of the toner
save mode operation.
(For the Japan and the UK versions.)
Section
Operation/Procedure
1) Select an item to be set with scroll keys.
2) Enter the set value with 10-key.
3) Press [OK] key.
The set value in step 2) is saved.
26-30
Purpose
Setting
Function (Purpose)
Used to set the operation mode corre-
sponding to the CE mark (Europe safety
standards). (For slow start to drive the fus-
ing heater lamp)
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value in step 1) is saved.
* Even in Enable state, the control may not be executed due
to the power frequency, etc.
26-32
Purpose
Setting
Function (Purpose)
Used to set the special functions.
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value in step 1) is saved.
26-35
Purpose
Setting
Function (Purpose)
Used to set the display mode of SIM 22-4
trouble history when a same trouble
occurred repeatedly. There are two display
modes: display as one trouble and display
as several series of troubles.
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value in step 1) is saved.
26-38
Purpose
Setting
Function (Purpose)
Used to set Continue/Stop of print when the
maintenance life is reached.
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value in step 1) is saved.
26-49
Purpose
Setting
Function (Purpose)
Used to set the print speed of postcards
mode.
Section
Operation/Procedure
Select the copy speed mode with the touch panel. (Default: LOW)
Item Display Content
Default
value
A COPY 0 Copy toner save mode is inhibited.
0
1 Copy toner save mode is allowed
B PRINTER 0 Printer toner save mode is inhibited.
0
1 Printer toner save mode is allowed.
0 Control allowed
1 Control inhibited
U.S.A 1 (CE not supported) EUROPE 0 (CE supported)
CANADA 1 (CE not supported) U.K. 0 (CE supported)
INCH 1 (CE not supported) AUS. 0 (CE supported)
JAPAN 1 (CE not supported) AB_A 0 (CE supported)
AB_B 1 (CE not supported) CHINA 0 (CE supported)
Item/Display Content Setting range
Default
value
A CLEANING
PRINT SET
The screen of the
cleaning mode self print
execution is displayed.
(ON)
0YES1(NO)
The screen of the
cleaning mode self print
execution is not
displayed. (OFF)
1NO
0 Only once display.
1 Any time display.
Item/Display Content
Default
value
A MAINTENANCE
LIFE OVER
(0: CONTINUE
1: STOP)
0 Setting of Print Continue/
Stop when the maintenance
life is over (Print Continue)
0
1 Setting of Print Continue/
Stop when the maintenance
life is over (Print Stop)
Item Setting
value
Content
Default
value
POSTCARD LOW Postcard copy speed LOW LOW
HIGH Postcard copy speed HIGH