Sharp MX-M266N

MX-M316N SPECIFICATIONS 2 – 6
*2: Custom size
Long size paper (bypass tray only): support up to 1,200mm by Sim
* Long size paper ejection is from center tray/inner finisher
*3: Comply to “Paper type setting”
*4: Can be input but alignment is not supported
*5: Can be input and stapled but alignment is not supported
*6: Alignment of heavy paper more than 129g/m
2
is not supported
*7: Only front/back cover is available.
*8: Can be fed but not covered under warranty.
*9: A4 paper (grain long) corresponding to 58g/m
2
I. Operation panel
J. Controller board
*1: The USB port can be disabled by Sim
K. Memory/Hard disk/SD card memory
*1: Memory expansion is not available
*2: HDD capacity may vary depending on the procurement condi-
tion.
L. Warm-up time
* Result may change depending on conditions.
*1: Conditions: Leave the machine for 60 sec. after door open,
standard condition, Polygon stops.
2. Copy functions
A. First copy time
* Measuring Conditions
Feed the A4 (8-1/2 x 11) sheet in landscape from tray 1, with the
polygon rotating condition.
Value might vary depends on the machine settings/conditions
B. Job Speed
* Defines the copy speed of when the main unit and a document
feeder are used in combination.
* S to S: copying 1 set of an 11-sheet original in A4 / 8.5" x 11"
(not including the first copy)
Monochrome: 600 x 400dpi (default)
AB System (mm) Inch System (inch)
Min. Max. Min. Max.
Bypass tray X 140 432 5-1/2 17
Y 100 297 5-1/2 11-5/8
Duplex X 182 432 7-1/4 17
Y 148 297 5-1/2 11-5/8
Size 7 inch
Form Dot matrix LCD, Touch panel
Display dot number 800 x 480 dots (WVGA)
LCD backlight LED backlight
LCD contrast adjust Yes
Angle/position adjustment No tilting mechanism
CPU ARM11: 600MHz
ARM9: 400MHz/during 1W energy save mode:
75MHz
Interface
IEEE1284 Parallel No
Ethernet 1port
Interface 10Base-T, 100Base-TX, 1000Base-T
Support Protocol TCP/IP (IPv4, IPv6), IPX/SPX, Ether Talk
USB 2.0 (high
speed) (host)*
1
2port
(Simultaneous use of the front/rear ports is
enable.)
USB 2.0 (high
speed) (device)
1port
USB-HUB (host) Internal: 4port
* Main unit USB Front Port
* Main unit USB Rear Port
* Key board USB Port
* IC Card Reader
Serial I/F
(For coin-operated
machines)
1port
SD card
ICU (Reus) PWB
HDD*
2
Memory*
1
4GB 2GB OPT (250GB)
Memory area
(SD card)
Boot/Program area
FAX data storage area
Without HDD With HDD
512MB 1GB
Warm-up time 20sec. or less
Pre heat Yes
Jam recovery time
*1
10sec. or less
Engine 26cpm machine 31cpm machine
35cpm
machine
Scan Speed 31 56 31 56
56
Platen 4.3 sec. 4.3 sec. 4.3 sec. 4.3 sec.
4.0 sec.
RSPF 7.0 sec. 7.0 sec. 7.0 sec. 7.0 sec.
6.7 sec.
Engine
26cpm
machine
31cpm
machine
35cpm
machine
S to S 26cpm (100%) 31cpm (100%)
35cpm (100%)
1
: ‘15/Aug.
1
1