MX-M316N SIMULATION 6 – 63
53-8
Purpose
Adjustment
Function (Purpose)
Used to adjust the document lead edge ref-
erence and the RSPF mode document
scan position.
Section
Operation/Procedure
Select an adjustment item with [AUTO] [MANUAL] key.
AUTO: Document lead edge reference (RRCA) adjustment
(Auto adjustment)
1) Set a sheet of black paper of A4 or 11"x 8.5" on the document
table.
2) Press [EXECUTE] key. (The adjustment is performed and the
adjustment value is saved.)
MANUAL: RSPF mode document scan position adjustment
1) Enter the set value with 10-key.
2) Press [OK] key. (The set value is saved.)
* When the adjustment value is increased, the scanner stop posi-
tion in the RSPF mode is shifted to the right.
* When the adjustment value is changed by 1, the position is
shifted by 0.1mm.
53-9
Purpose
Adjustment
Function (Purpose)
Set dirt detection for SPF scanning posi-
tion.
Section
Operation/Procedure
1) Select an item to be set with the scroll key.
2) Enter the set value with 10-key.
3) Press [OK] key. (The set value is saved.)
53-10
Purpose
Adjustment/Setup
Function (Purpose)
SPF dirt detection execution.
Section
Operation/Procedure
1) Press [EXECUTE] key.
Item/Display Content
Setting
range
Default
value
MEASUREMENT
DISTANCE
Document lead edge
measurement distance
0-255
(0.1mm unit)
-
RRCA Document lead edge
reference position
0 - 99 50
Item/Display Content
Setting
range
Default
value
A ADJUST
VALUE
RSPF mode document scan
position adjustment (Scanner
stop position adjustment)
1 - 99 5
Item/Display item, Details of display Content
Setting
range
Default
value
A DIRT_ALARM_SET SPF front surface optimum scan position detection setting (when
starting)
OFF 0 - 1 0 0
(OFF)
ON 1
B SIDEA_SCAN_POSIION _SET_START SPF front surface optimum scan position detection setting (After a
job)
OFF 0 - 1 0 0
(OFF)
ON 1
C SIDEA_SCAN_POSITION_SET_JOB SPF front surface optimum scan position detection level setting WEAK 0 - 1 0 1
(ON)
MIDDLE 1
STRONG 2
D SIDEA_SCAN_POSITION_LV OC dirt level setting WEAK 0 - 2 0 1
(MIDDLE)
MIDDLE 1
STRONG 2
E OC_DIRT_LV SPF front surface dirt alarm level setting WEAK 0 - 2 0 1
(MIDDLE)
MIDDLE 1
STRONG 2
F SIDEA_DIRT_ALARM_LV SPF back surface dirt alarm level setting WEAK 0 - 2 0 1
(MIDDLE)
MIDDLE 1
STRONG 2
G SIDEA_DIRT_SHADING_SET SPF front surface streak delete shading setting OFF 0 - 1 0 1
(ON)
ON 1
Item/Display Content
SPF SIDEA SPF front surface dirt detection position (main scan
position 1 to 8) "-": No dirt, A"*": Dirt
OC OC surface dirt detection position (main scan
position 1 to 8) "-": No dirt, "*": Dirt
To Next Page
Loading...
