Sharp MX-M266N

MX-M316N OPERATIONAL DESCRIPTIONS 11 – 5
7) After reversing, registration operation is executed.
8) After turning ON the PS clutch, the reverse follower roller pres-
sure is released.
9) Scanning start (First sheet, back surface)
10) After completion of scanning, the reverse follower roller is
pressed.
11) After stopping the operation, reversing is started.
12) After reversing, registration operation is executed.
13) After turning ON the PS clutch, the reverse follower roller pres-
sure is released.
14) Scanning start (Second sheet)
15) After passing the scanning section, the reverse follower roller is
pressed.
16) After discharge (First sheet), the reverse follower roller pressure
is released.