COPYING SEQUENCE
This section explains the basic procedure for copying. Select settings in the order shown below to ensure that the copy
operation takes place smoothly.
For detailed procedures for selecting the settings, see the explanation of each setting in this chapter.
Place the original.
Place the original in the document feeder tray of the automatic
document feeder, or on the document glass.
* Depending on the copy functions used, there are also cases
where functions are selected before the original is placed.
Basic copy settings
Select the basic copy settings.
The main settings are as follows:
• Color mode
☞
COPY COLOR MODES
(page 2-20)
• Exposure and original type
☞CHANGING THE
EXPOSURE AND ORIGINAL IMAGE TYPE (page 2-22)
• Copy ratio
☞REDUCTION/ENLARGEMENT/ZOOM
(page 2-24)
• Original size
☞ORIGINAL SIZES (page 2-28)
• Paper Settings
☞PAPER TRAYS (page 2-10)
2-sided copy settings
Select settings as needed for 2-sided copying and 2-sided
scanning of the original.
☞ AUTOMATIC 2-SIDED COPYING (page 2-15)
To Next Page
Loading...
