LOADING PAPER IN THE BYPASS TRAY
The bypass tray can be used to print on plain paper, envelopes, label sheets, and other special media. Up to 50 sheets
of paper can be loaded (up to 20 sheets of heavy paper) for continuous printing similar to the other trays.
To feed an envelope, first press down the fusing unit release levers (2 places) to release the pressure, and then follow
the steps below.
1
Open the bypass tray.
Open out the bypass tray extension.
2
Push the center of the pressure plate
down until it locks into place.
3
Set the paper guides to the copy paper
width.
To Next Page
Loading...
Need help?
General
