This section explains the basic procedures for making copies, including selection of the copy ratio and other copy
settings.
MAKING COPIES
USING THE AUTOMATIC DOCUMENT FEEDER TO
MAKE COPIES
This section explains how to make copies (1-sided copies of 1-sided originals) using the automatic document feeder.
BASIC PROCEDURE FOR MAKING
COPIES
1
Place the originals face up in the
document feeder tray with the edges
aligned evenly.
Insert the originals all the way into the document feeder tray.
Multiple originals can be placed in the document feeder tray.
The stack of originals must not be higher than the indicator line
on the tray.
2
Check the paper to be used and the
color mode.
Make sure that the desired paper (tray) and color mode are
selected.
• To change the original size, touch the [Original] key.
☞ ORIGINALS (page 2-9)
• To change the paper (tray), touch the [Paper Select] key.
☞ PAPER TRAYS (page 2-10)
• To change the color mode, touch the [Color Mode] key.
☞ COPY COLOR MODES (page 2-20)
Indicator
line
To Next Page
Loading...
Need help?
General
