ShopBot PRS Assembly Manual Page -32
We recommend applying grease to the rack and pinions. A good quality bearing, lithium, or
Teflon grease will work well. The grease will keep the rack motion smooth and reduce gear
wear. (Surprisingly little debris actually collects in the grease.) Apply it by squeezing a little
into the rack every few inches. Moving the tool around will spread the grease and you can
wipe off any excess. It’s OK to push the cars around, but do not plug them in to the
Control Box yet.
PRSAssembly080922.doc Copyright 2007,2008 ShopBot Tools, Inc
To Next Page
Loading...
