Siare Morpheus Series - 6 Preparation to Use

Preparation to use
User’s Manual, DU3310103-MRI / rev.3 - 02.05.2019
6-1
6 PREPARATION TO USE
In the first part of this chapter is illustrated how to install the MORPHEUS LT/MRI
anaesthesia unit. In the second part it is illustrated how to perform the preliminary
tests before using the MORPHEUS LT/MRI anaesthesia unit.
6.1 General warnings
6.2 Before the use
6.2.1 Assembling of O
2
cell
6.2.2 Flow sensor assembling
6.2.3 Assembling of absorber canister
6.2.4 Battery charger
6.3 Preparation to use
6.3.1 Medical gas connection
6.3.2 Connection of anesthetic gases scavenging system
6.3.3 Patient circuit connections
6.3.4 Fresh gases exit – TO and FRO patient circuit
6.3.5 Connection of circuit for manual ventilation
6.3.6 Use of antibacterial filter
6.3.7 Mains power supply
6.3.8 Protection fuses
6.3.9 Connection to other equipments
6.3.10 Table of predisposition sequence for use
6.4 Preliminary tests - Introduction
6.4.1 Verification activity - “ SELF TEST “
6.5 Preliminary checks – Operating phase
6.5.1 Preliminary checks
6.5.2 Preliminary checks – Flowmeter box
6.5.3 Preliminary tests – Lung Ventilator
6.5.4 Preliminary tests - Alarms
6.5.5 Preliminary tests sequence table