Preparation to use
6-10 MORPHEUS MRI
Follow the instructions.
• Connect the outlet of the power cable to
the plug on the anaesthesia unit.
• Insert the plug of the power cable in the
mains supply wall socket.
The electric main power supply must
correspond to that indicated in the
identification label in tbe back side of the
machine.
• Turn the main switch (located in the
back side of the unit) in position “I”.
• Verify on the front module of ventilator
(user’s control area) if the green led is
light on (it indicates the main power
supply).
To ensure maximum autonomy of
operation, it is necessary to guarantee
sufficient recharging time.
To bring the charge level from 0 to 90%
takes approximately 10 hours recharging
through the mains power supply.
It is not necessary to start-up the anaesthesia unit.
To Next Page
Loading...
