SICK FLOWSIC600

FLOWSIC600 · Operating Instructions · 8010458 V 2.0 · © SICK MAIHAK GmbH 19
Product Description
****The “active” or “inactive” state can be assigned to the electric switch status
“normally open” or “normally closed” by configuration in the MEPAFLOW600 CBM software
(adjust settings for register #5101 on the “Parameters” page.)
The LCD display is capable of displaying measured values, parameters, messages and
other information.
A flashing letter at the upper right corner of the LCD display indicates that a logbook
contains unacknowledged logbook entries. Depending on the type of entry this will be:
● “I” for Information
● “W” for Warning
● “E” for Error
After acknowledging all new entries, the flashing letter disappears. For details see
→ pg.68,
5.4.1.
Table 2 Status output
Output signal / LCD / port
Signal behavior
Measurement state Check request state Configuration Mode Measurement invalid
“Check request”
Status signal
Status
“active / inactive” ***
Measurement valid
Status
“active / inactive” ***
Compensation of path
failure
“undefined” “undefined”
“Direction of flow”
Status signal
Status
“active / inactive” ***
Positive or negative
direction of flow
Status
“active / inactive” ***
Positive or negative
direction of flow
“undefined” “undefined”
“Warning” Status
“active / inactive” ***
Status
“active / inactive” ***
“undefined” “undefined”
LCD display
Display flashing Display flashing
Serial port RS485
● Measured value, diagnosis information and parameters
● Measuring data logging, diagnosis and configuration through the MEPAFLOW600
CBM software
● Connection with external process control equipment through implemented
MODBUS protocol (data polling)
+V 123456 m³
-V 1234 m³
1234 m³
FLOWSIC600
Configuration
+V 123456 m³
-V 1234 m³