SICK FLOWSIC600

Appendix
80 FLOWSIC600 · Operating Instructions · 8010458 V2.0 · © SICK MAIHAK GmbH
7.1
Conformities and Technical Data
7.1.1 CE certificate
The FLOWSIC600 has been developed, manufactured and tested in accordance with the
following EC directives:
● Pressure Equipment Directive 97/23/EC
● Directive 94/9/EC (ATEX100)
● EMC Directive 2004/108/EC
Conformity with above directives has been verified. The equipment has been designated
the CE label. The specific designation of the pressure equipment demanded according to
the Pressure Equipment Directive 97/23/EC under part 3.3 and 3.4 is to find in the MDR
of the FLOWSIC600.
7.1.2 Standard compatibility and type approval
The FLOWSIC600 conforms to the following norms, standards or recommendations:
● EN 60079-0, EN 60079-1, EN 60079-7, EN 60079-11, EN 60079-26
● OIML R 137-1, 2006, “Gas meters, Part 1: Requirements“
● OIML D 11, 2004, “General requirements for electronic measuring instruments“
● A.G.A Report No. 9, 1998, “Measurement of Gas by Multipath Ultrasonic Meters“
1
●
API 21.1 “Flow Measurement Using Electronic Metering Systems” (draft)
2
Type approval for commercial or custody transfer has been granted by the relevant
authorities, e.g.:
● Germany: PTB (Physikalisch-Technische Bundesanstalt), code number 7.421 / 03.05
● Netherlands: NMI (Netherlands Meetinstituut), code number B35
● Canada: Measurement Canada, Approval No. AG-0521
● Switzerland: Metrologie und Akkreditierung Switzerland, Appr. No. CH-G4-04404-00
● Europe: MID Approval, DE-08-MI002-PTB005
1 In derogation of the AGA9, strength test will be performed as hydrostatic pressure test with 30 minutes
holding time according to the requirements of PED and ASME B31.5 “Process piping”.
2 The FLOWSIC600 meets or exceeds the new proposed audit logging requirements of API 21.1 (draft).
Specifically the API 21.1 (draft) requires the ultrasonic meter to provide an internal record of any
configuration change, including the original and new parameter, and date and time the change
occurred.