SICK FLOWSIC600

Installation
36 FLOWSIC600 · Operating Instructions · 8010458 V2.0 · © SICK MAIHAK GmbH
3.4.4 Terminal enclosure on the SPU
Opening the rear housing cover
b Loosen the securing clip using a 3 mm Allen key.
b Turn the rear housing cover counter-clockwise and take it off.
A schematic wiring diagram is provided on the inside of the rear housing cover.
Figure 10 SPU housing
Figure 11 Terminal box on the rear of the SPU (see Section → 3.4.2 for North American wiring specification equivalents)
NOTICE: Lubricant
Only use LOCTITE 8156 as lubricant for front and rear housing cover.
Open the cover
Cover
Securing clip
Cover for power
supply terminals
Cable entry for internal 10-
core cable
10-pole terminal block
for signal inputs and outputs
1
2
HSK-K type cable glands,
M 20 x 1.5 plastic (EU)
or ½ in NPT (North America)
Power supply
2 x 1.5 mm
2
(LiYCY or equivalent)
Digital output / current
output
4 x 2 x 0.5 mm
2
(Li2YCY [TP] or equivalent)
MODBUS
4 x 2 x 0.5 mm
2
(Li2YCY [TP] or equivalent)
Bridge