SICK LFP CUBIC

OPERATING INSTRUCTIONS | LFP CUBIC 8019918/ZJA6 / 2017-07-20 | SICK AG
Subject to change without notice
14
4 TRANSPORT AND STORAGE
4 Transport and storage
4.1 Transport
For your own safety, please read and observe the following notes:
IMPORTANT
Damage to the sensor due to improper transport.
• The device must be packaged for transport with protection against shock and damp.
• Recommendation: Use the original packaging as it provides the best protection.
• Transport should be performed by specialist sta only.
• The utmost care and attention is required at all times during unloading and
transportation on company premises.
• Note the symbols on the packaging.
• Do not remove packaging until immediately before you start mounting.
4.2 Transport inspection
Immediately upon receipt at the receiving work station, check the delivery for
completeness and for any damage that may have occurred in transit. In the case of
transit damage that is visible externally, proceed as follows:
• Do not accept the delivery or only do so conditionally.
• Note the scope of damage on the transport documents or on the transport
company's delivery note.
• File a complaint.
Note:
Complaints regarding defects should be led as soon as these are detected. Damage
claims are only valid before the applicable complaint deadlines.
4.3 Storage
Store the device under the following conditions:
• Recommendation: Use the original packaging.
• Do not store outdoors.
• Store in a dry area that is protected from dust.
• To ensure that any residual moisture present can escape, do not store
in airtight containers.
• Do not expose to any aggressive substances.
• Protect from sunlight.
• Avoid mechanical shocks.
• Storage temperature: see “12 Repair work”.
• Relative humidity: see “12 Repair work”.
• For storage periods of longer than 3 months, check the general condition
of all components and packaging on a regular basis.