SICK LFP CUBIC User Manual

OPERATING INSTRUCTIONS | LFP CUBIC 8019918 /ZJA6/ 2017-07-20 | SICK AG
Subject to change without notice
9
2SAFETY INFORMATION
2.5 Requirements for skilled persons and operating personnel
WARNING
Risk of injury due to insucient training.
Improper handling of the sensor may result in considerable personal injury and material
damage.
• All work must only ever be carried out by the stipulated persons.
The operating instructions state the following qualication requirements for the various
areas of work:
• Instructed personnel have been briefed by the operator about the tasks assigned
to them and about potential dangers arising from improper action.
• Skilled personnel have the specialist training, skills, and experience, as well as
knowledge of the relevant regulations, to be able to perform tasks delegated to
them and to detect and avoid any potential dangers independently.
• Electricians have the specialist training, skills, and experience, as well as
knowledge of the relevant standards and provisions to be able to carry out work on
electrical systems and to detect and avoid any potential dangers independently.
In Germany, electrical specialists must meet the specications of the BGV A3 Work
Safety Regulations (e.g., Master Electrician). Other relevant regulations applicable
in other countries must be observed.
The following qualications are required for various activities:
Activities Qualication
Mounting, maintenance
• Basic practical technical training
• Knowledge of the current safety regulations in the workplace
Electrical installation,
device replacement
• Practical electrical training
• Knowledge of current electrical safety regulations
• Knowledge of device control and operation in the particular
application concerned (e.g.conveying line)
Commissioning,
conguration
• Basic knowledge of the control system in use
• Basic knowledge of the design and setup of the described
connections and interfaces
• Basic knowledge of data transmission
Operation of the device for
the particular application
• Knowledge of device control and operation in the particular
area of application concerned (e.g. bottling plant)
• Knowledge of the software and hardware environment for the
particular application concerned (e.g. bottling plant)
2.6 Operational safety and particular hazards
Please observe the safety notes and the warnings listed here and in other chapters
of these operating instructions to reduce the possibility of risks to health and avoid
dangerous situations.

SICK LFP CUBIC Specifications

General

Brand	SICK
Model	LFP CUBIC
Category	Measuring Instruments
Language	English