SICK LFP CUBIC

OPERATING INSTRUCTIONS | LFP CUBIC 8019918 /ZJA6/ 2017-07-20 | SICK AG
Subject to change without notice
53
11TROUBLESHOOTING
Error Cause Possible solution
Display o Temperature is too high. Reduce the temperature.
Temperature is too low. Increase the temperature.
No supply voltage. Connect the sensor correctly.
!Err[xx]
!ErM[xx]
!ErI[xx]
!ErO[xx]
System error. The device is defective and must be replaced.
NVFail Memory error. The device is defective and must be replaced.
11.2 Operating the display
Error Cause Possible solution
The menu item SPx/
RPx is not displayed.
QxMENU/OUx is not
congured to Qx-Hno and/or Qx-Hnc.
Congure Qx (see “8.2 Conguring the switching
outputs”).
The menu item FHx/
FLx is not displayed.
QxMENU/OUx is not
congured to Qx-Fno and/or Qx-Fnc.
Congure Qx (see “8.2 Conguring the switching
outputs”).
QAFAIL Is not
displayed.
The analog output Qa is in voltage mode
(QATYP = 0 to 10 V).
Congure Qa (see “8.3 Congure the analog
output”).
SimVol is not
displayed.
The analog output Qa is in current mode
(QATYP = 4 to 20 mA).
Congure Qa (see “8.3 Congure the analog
output”).
SimCur is not
displayed.
The analog output Qa is in voltage mode
(QATYP = 0 to 10 V).
Congure Qa (see “8.3 Congure the analog
output”).
EXPRT-Cong-… is
not displayed.
Correct password not entered. See “8.4.1 Expert mode”.
EXPRT-Foam-… is
not displayed.
Correct password not entered. See “8.4.1 Expert mode”.
Lengths are
expressed as
decimal numbers.
Inch is activated as the display unit. Congure the unit (see“8.4.12 Selecting the
display unit (millimeter/inch)”).
The menu only
shows PASSW.
The display lock is activated. See “8.4.11 Activating the display lock”.