7SR210 & 7SR220 Description of Operation
Unrestricted Page 76 of 94 ©2018 Siemens Protection Devices Limited
P.U. DELAY
D
.
O
.
D
ELAY
Figure 4.12-1Sequence Diagram: Quick Logic PU/DO Timers (Counter Reset Mode Off)
When the count value = En Counter Target the output of the counter (En) = 1 and this value is held until the
initiating conditions are removed when En is instantaneously reset.
The output of En is assigned in the OUTPUT CONFIG>OUTPUT MATRIX menu where it can be programmed to
any binary output (O), LED (L) or Virtual Input/Output (V) combination.
Protection functions can be used in Quick Logic by mapping them to a Virtual Input / Output.
Refer to Applications Guide for examples of Logic schemes.
To Next Page
Loading...
