Siemens Clinitek Advantus User Manual

78 Clinitek Advantus Operator’s Guide
System Configuration
Install the Push Bar
1. Hold the push bar at the indented end.
2. With this end slightly upward, insert the peg on the other end of the bar into
the hole in the pusher mechanism.
3. Lower the push bar into place.
Figure 27 Install the Push Bar

Siemens Clinitek Advantus Specifications

General

Test Types	Urinalysis
Interface	RS-232, USB
Calibration	Automatic calibration
Measurement Principle	Reflectance photometry
Sample Type	Urine
Power Supply	100-240 VAC, 50/60 Hz
Type	Urine analyzer
Display	Touchscreen
Reagent Type	Test strips
Measurement Parameters	Glucose, Bilirubin, Ketone, Specific Gravity, Blood, pH, Protein, Urobilinogen, Nitrite, Leukocytes