– 'Action': 'Allow the connection'
4. Select the 'Protocol and Ports' tab.
5. Set the following values:
– 'Protocol type': 'UDP'
– 'Local port': 'Specific Ports', and then enter the value range '69' in the box.
– 'Remote port': 'All Ports'
6. Confirm with 'OK'.
The new firewall rule is now configured.
● Deactivate the above configurations after firmware update.
Supported web browsers
Once there is a functioning Ethernet connection, 'FC360 Desktop Editor 2.0' and
'FC360 Panel Configurator' can be accessed via one of the following browsers:
● Google Chrome Version 71 (or above)
● Microsoft Edge Version 81 (or above)
● Firefox Standard Version 77 (or above)
To Next Page
Loading...
