Siemens FC361 Series - Wiring on C-NET Devices

Installation
C-NET detector line
6
38 | 151
A6V10421795_en--_k
6.6.3 Wiring on C-NET devices
The connection terminals for the loop(s) (↑ detector line, C-NET) are on the
mainboard. The position is shown as below.
Fig. 9: Position of C-NET detector line terminal
Panel type specific. Only FC362-xx supports two loops.
Each C-NET device has the terminals for directly connecting the C-NET wire.
Loop wiring
Connection terminal
Detector base and sounder base
● 1b (corresponds to +,
input/output)
● 5 (corresponds to input)
● 6 (corresponds to output)
Manual call point
Input/output modules
Zone module
Alarm device with supplementary
optical indication
Loop connection of C-NET detector line
LOOP1
LOOP2