Siemens FC361 Series - Recovering short fault of a detector line

Troubleshooting
Accessories
12
A6V10421795_en--_k
125 | 151
12.3 Accessories
Description
Cause/Action
DC 24 V too low
Check voltage input '24V' on the output card FCA3602-
Z1.
Outputs from output
card (4M) indicates a
fault
Check the cable connection and output line.
EVAC fault
Check the cable connection. Replace the device if the
fault still appears.
Key switch does not
work
Check the cable connection. Replace the device if still not
working.
LED indication
module does not work
Check the cable connection. Replace the device if still not
working.
Contact your service provider if you cannot eliminate a fault.
12.4 Recovering short fault of a detector line
 A short fault message is displayed.
1. Restart ↑ detector line. See chapter 'Restart [➙ 90]'.
2. Read the information event to find the two devices with open isolators. See
chapter 'System status [➙ 72]'.
3. Go to the fault location to eliminate it.
4. Restart the detector line.
 Short fault message and isolator open information message disappear.