Siemens FC361 Series - Viewing Event Memories

Operation
Operations under access level 2
8
A6V10421795_en--_k
81 | 151
8.5.3 Viewing event memories
8.5.3.1 Viewing event logs
All events that happened in the fire detection system are stored in event logs. You
can view them one by one on the panel or view them all in a PC after uploading.
See 'Backing up event logs to the PC [➙ 118]' for more information about viewing
event logs in a PC.
There are 8 event categories:
● Alarm
● Fault
● Technical
● Isolation
● Test
● Activation
● Information
● Operation
The event lists are sorted chronologically and can be filtered by category and time.
When you view event logs, the displayed view is almost the same as 'Event views
[➙ 66]'. Device IDs in event logs are only visible for access level 3 or above, as is
the case with device IDs in event views. In addition, the symbols '+', '-', 'c' are
displayed in front of the event type to indicate the processing status of the event:
1. '+': event in
2. '-': event out
3. 'c': operation on ↑ PMI
To view all events
1. Press on the keypad. The 'Main menu' window is open.
Main menu L2
1 - System status
2 - Operation
3 - Event memory
4 - Login
5 - Lamp test
7 - Logout
2. Select 'Event memory' and press . The 'Event memory' window is open.
Event memory L2
1 - Event log
3 - Compensation Value
3. Select 'Event log' and press . The 'Event log' window is open.