4. Select 'Locate' and press .
The 'Locate' window is open.
5. Select 'Lines' and press .
A list of all detector lines is displayed.
6. Select one line and press .
Two commands are listed: 'Locate' and 'Quit locate'.
7. Select 'Locate' and press .
A confirmation window is displayed.
8. Press to confirm.
All the devices in the selected line are located.
The LED indicators on the devices are flashing.
9.4.6.4 Locating a single device
This function is used to find a single device (element) on site.
1. Press on the keypad.
The 'Main menu' window is open.
2. Select 'Engineering' and press .
The 'Engineering' window is open.
3. Select 'Detector line' and press .
The 'Detector line' window is open.
4. Select 'Locate' and press .
The 'Locate' window is open.
5. Select 'Element' and press .
A list of all single devices is displayed.
6. Select one desired element and press .
Two commands are listed: 'Locate' and 'Quit locate'.
7. Select 'Locate' and press .
A confirmation window is displayed.
8. Press to confirm.
'ON' is displayed on the screen, indicating that the element is now being
located.
The LED indicator on the element is flashing.
9.4.6.5 Quitting locating devices
1. Press on the keypad.
The 'Main menu' window is open.
2. Select 'Engineering' and press .
The 'Engineering' window is open.
3. Select 'Detector line' and press .
The 'Detector line' window is open.
4. Select 'Locate' and press .
The 'Locate' window is open.
5. Select 'Zones', 'Element', 'Devices' or 'Lines' and then press .
A list of all subparts is displayed.
6. Select one desired subpart and press .
Two commands are listed: 'Locate' and 'Quit locate'.
To Next Page
Loading...
