3.2 Insert NX module
Procedure
In order to insert an NX module into the project via the hardware catalog, proceed as follows:
1. In the network view, navigate in the hardware catalog to the folder "Controller > SINUMERIK
840D sl > NX" and select, for example, NX15.3 .
2. You can select the firmware version of the NX module at "Information" in the hardware
catalog. This must match the firmware version of the NCU. Firmware versions of the
configured hardware and the real hardware must match.
Configuring the NCU
3.2 Insert NX module
SINUMERIK STEP 7 Toolbox V15.1
28 Configuration Manual, 12/2018, A5E46279635B AA
To Next Page
Loading...
Need help?
General
