Procedure
To export PLC symbols for SINUMERIK Operate, proceed as follows:
1. In the project tree, right-click on the PLC or NCU and select the "Export PLC symbols for
SINUMERIK Operate " in the shortcut menu.
The "Export PLC symbols for SINUMERIK Operate" dialog opens.
2. Enter the settings:
– Select the languages whose PLC symbols you want to export. Only those languages that
you previously selected under "Project languages" are actively displayed.
Note
Comments only in German or English
Because SINUMERIK Operate can manage only German and English comments, you
can export only German and English comments from the TIA Portal.
Programming the PLC
4.10 Exporting PLC symbols for SINUMERIK Operate
SINUMERIK STEP 7 Toolbox V15.1
88 Configuration Manual, 12/2018, A5E46279635B AA
To Next Page
Loading...
Need help?
General
