Examples
13.3 Preparing the examples
FM 352 electronic cam controller
Operating Instructions, 05/2011, A5E01071724-03
153
13.3 Preparing the examples
Procedure
In order to work through the examples online, you must prepare as follows:
1. Open the \STEP7\EXAMPLES\zEn19_02_FMx52___Prog example project in
SIMATIC Manager, then copy it under a suitable name to your project folder.
2. Insert a station in this project according to your hardware configuration.
3. Complete the hardware configuration with HW Config and save the configuration.
4. Select an example program and copy its block container to your station.
5. Assign parameters for the FM 352 in HW Config using the instructions provided in the
SIMATIC Function Modules FM 352 - First Steps in Commissioning, section FM 352
parameter assignment (http://support.automation.siemens.
com/W
W/view/en/1407842).
6. Enter the module address in the associated channel DB and, if necessary, also in the
corresponding diagnostic DB in the "MOD_ADDR" parameter (refer to the section entitled
Basics of Programming an FM 352 (Page 40)).
7. Download the
hardware configuration to your CPU.
8. Download the blocks to your CPU.
9. To try out the next example, go to step 4.
13.4 Displaying the code of the examples
Display
The samples are written in STL.
You can view them directly in the LAD/STL/FBD editor.
Select the view with "Symbolic representation", "Symbol selection" and "Comment." If your
screen provides sufficient space, you can also open the "Symbol information" view.
To Next Page
Loading...
