Siemens S7-300 - Interrupt Enable

Machine and cam data
9.13 Interrupt enable
FM 352 electronic cam controller
96 Operating Instructions, 05/2011, A5E01071724-03
9.13 Interrupt enable
Definition
In the cam data, you can specify whether hardware interrupts are to be generated when
cams 0 to 7 are activated and/or deactivated (see chapter "Cam data (Page 97)").
Machine data for interrupt enable in the parameter DB
Address
Absolute
Name Type Start value Comment
3.2 PI_CAM BOOL FALSE 1 = enable hardware interrupt: cam on/off
Cam data for interrupt enable in the parameter DB
Address
relative
Name Type Start value Comment
+0.4 PI_SW_ON BOOL FALSE 1 = hardware interrupt on activation
+0.5 PI_SW_OFF BOOL FALSE 1 = hardware interrupt on deactivation